 |
JH-3535V12G45-T8A-370
LEDGUHON
Typical Applications:
• UV gluing, UV curing, UV marking
• UV drying of printing inks and lacquers
• Currency inspection
• Detects fluorescing minerals and gems
• Portable LED Flashlight
• Automobile illumination
• Architectural lighting
• Landscape lighting
• LED Street Light, LED High Bay Lights, LED Tunnel Lights
• Secruity application CCTV products
• 3D pringing
Data:
| Parameter | Symbol | Color | Min | Type | Max | Unit | Test Condition |
| Forward Voltage | VF | UV | 3.2 | 3.4 | 3.6 | V | IF=700mA |
| Luminous Power | PO | UV | 800 | 1000 | 1200 | mW | IF=700mA |
| Wavelength | Wld | UV | 365 | 367.5 | 370 | NM | IF=700mA |
| Reverse Current | IR | ||||||
| Viewing Angle | 1/2 | 120 | Deg | IF=700mA | |||
| Recommend Forward Current | IF(rec) | UV | 700 | mA |
Precautions:
• Pressure on the LEDs will influence the reliability of the LEDs. Precautions should be taken to avoid intense pressure on the LEDs. Do not put stress on the LEDs during heating.
• Re-soldering should not be done after the LEDs have been soldered. If re-soldering is unavoidable, LED`s characteristics should be carefully checked before and after such repair.
• Do not stack assembled PCBs together. Since the materials of LEDs are soft, abrasion between two PCBs assembled with LED might cause catastrophic failure of the LEDs.
Typical Applications:
• UV gluing, UV curing, UV marking
• UV drying of printing inks and lacquers
• Currency inspection
• Detects fluorescing minerals and gems
• Portable LED Flashlight
• Automobile illumination
• Architectural lighting
• Landscape lighting
• LED Street Light, LED High Bay Lights, LED Tunnel Lights
• Secruity application CCTV products
• 3D pringing
Data:
| Parameter | Symbol | Color | Min | Type | Max | Unit | Test Condition |
| Forward Voltage | VF | UV | 3.2 | 3.4 | 3.6 | V | IF=700mA |
| Luminous Power | PO | UV | 800 | 1000 | 1200 | mW | IF=700mA |
| Wavelength | Wld | UV | 365 | 367.5 | 370 | NM | IF=700mA |
| Reverse Current | IR | ||||||
| Viewing Angle | 1/2 | 120 | Deg | IF=700mA | |||
| Recommend Forward Current | IF(rec) | UV | 700 | mA |
Precautions:
• Pressure on the LEDs will influence the reliability of the LEDs. Precautions should be taken to avoid intense pressure on the LEDs. Do not put stress on the LEDs during heating.
• Re-soldering should not be done after the LEDs have been soldered. If re-soldering is unavoidable, LED`s characteristics should be carefully checked before and after such repair.
• Do not stack assembled PCBs together. Since the materials of LEDs are soft, abrasion between two PCBs assembled with LED might cause catastrophic failure of the LEDs.
